Toolex 597076, Инструкция по эксплуатации

Страница: 15 / 16

15 / 16
15
CLEARANCE FORM
MAINTENANCE
WARNING! Make sure the Power
Switch of the welder is in its “OFF”
position and that the tool is unplugged
from the electrical outlet before
performing
any inspection,
maintenance, or cleaning procedures.
1. Before each use, inspect the general
condition of the Welder. Check for
loose cable connections, misalignment
or binding of the fan, cracked or
broken parts, damaged electrical
wiring, and any other condition that
may affect its safe operation. If
abnormal noise or vibration occurs,
have the problem corrected before
further use. Do not use damaged
equipment.
2. Periodically recheck all nuts, bolts,
and screws for tightness.
3. Periodically blow the dust from the
cooling vents with compressed air.
4. Verify that the cooling fan is
operational before cutting.
5. If the unit repeatedly shuts down from
thermal overload, stop all use. Have
the welder inspected and repaired by
a qualified service technician.
6. Store the welder and accessories in a
clean and dry location.
7. Periodically disassemble and clean
the Torch Head components with steel
wool.
Replace burnt, cracked,
distorted, or coated components,
Refer to the assembly drawing on
page 11.
8. To gain access to the internal
components of the unit, remove
screws from Main Body Cover. The
home user is strongly advised not to
remove the tool covers and not to
attempt any electronic repairs. Any
repairs must be completed by a
qualified technician. Opening the tool
will void any warranties, and may
result in damage to equipment or
possible personal injury. Don’t do it.
9. On a daily basis check for any of the
following problems: If any are found,
take the tool to a qualified repair
technician.
a. Abnormal vibration, sound or
smell.
b. Abnormal heating at any cable
connection.
c. Then fan does not work properly.
d. Any switch or control does not
work properly.
e. Any damage to cables.