Toolex 535819, Инструкция по эксплуатации

Страница: 14 / 39

13
ASSEMBLE THE RAISING
AND TILTING HANDWHEELS AND LOCK KNOBS
1. Place the wheels in position over the raising and tilting screws being sure to engage the slots,
a (Fig.3), in back of each wheel with the roll pins, b(Fig.3), as shown at right.
2. Screw on lock knobs c(Fig.4), to hold wheels in place, then attach silver handles, d(Fig.4)
tightening them with the supplied 12mm combination wrench.
3. To use rising and tilting wheels, loosen lock nuts (but not too much or roll pins will disengage
from slots), turn wheels to desired position and retighten lock nuts. Do not operate saw with
lock nuts untightened as the blade could move out of position.
REMOVE GREASE FROM THE SAW TOP
The protective coating on the saw table top and extension wings
prevents rust from forming during shipping and storage. Remove it by
rubbing with a rag dipped in kerosene, mineral spirits or paint thinner.
(Dispose of potentially flammable solvent–soaked rags according to
manufacturer’s safety recommendations.) A putty knife, held flat to
avoid scratching the surface, may also be used to scrape off the
coating followed by clean–up with solvent. Avoid rubbing the saw’s
painted surfaces, as many solvent–based products will remove paint.
ASSEMBLE THE EXTENSION WINGS
Attach extension wings using the 6 hex head screws and lock
washers. Make screws only finger tight at first. Use a straightedge to
ensure that wing is level with table from front to back. Gently tap wing
up or down, then tighten screws with the supplied combination
wrench, leaving the center screw last to be tightened.
ASSEMBLE AND ADJUSTMENTS
Fig. 3 Fig. 4
Fig. 5
Fig. 6
a
b
c
d