34
6
Sharpening stone
• Use the sharpening stone (16) to clean dirty grinding tools, remove
grinding tools and to straighten grooves and other uneven surfaces.
7
Felt pads with holder
• Screw the felt washer (15) onto the holder (8). Use this to polish metals
and stone materials.
• Polish only with the edges. The front side leaves scratches on the
workpiece.
8
Cutting disc with holder
• Attach a cutting disc (1) to the holder (4). Tighten the screws. The cut-
ting discs are designed to cut metal parts, sheet metal, thin wood and
plastic.
9
Sandpaper disc
• Attach a sandpaper disc (2) to the corresponding holder (4). Tighten
the screws. The grinding discs are designed for grinding, smoothing
and shaping wood and glass fiber reinforced materials.
9. Operation
a) Clamping tools
• Press the spindle lock (B). Turn the shaft of the multi-purpose tool until you feel the locking pin in the main spindle
click into place. The bolt will sink into the locking hole in the spindle.
Never press the spindle lock while the tool is moving.
• If the collet chuck (12) cannot be opened by hand, use the supplied wrench (13) to loosen it. Loosen the union nut,
but do not completely unscrew it if you are not changing the collet chuck.
• Select the collet chuck with the correct size (2 sizes are available, 2.3 and 3.2 mm). Change it if necessary. One
of the clamps is located in the tool holders of the drive unit. The other is supplied separately as an accessory.
• Slide the tool shaft into the collet chuck. If necessary, remove the previous tool. Use the wrench to turn the collet
chuck as tightly as possible.
