2.
Position the RCK55 Receiver in the ceiling
cover so that the flat side of the receiver
faces up and the open portion of the receiv-
er is to the right, as shown in Figure 15.
10
OUTLET BOX
BLACK SUPPLY WIRE
BLACK/WHITE RECEIVER WIRE
BLACK FAN WIRE
BLUE FAN WIRE
BLUE RECEIVER
WIRE
YELLOW FAN WIRE
YELLOW RECEIVER WIRE
CEILING COVER
WHITE RECEIVER WIRE
WHITE FAN WIRE
WIRE CONNECTOR
RCK55 RECEIVER
WHITE SUPPLY
WIRE
SUPPLY
GROUND
WIRE (GREEN
OR BARE)
HANGER BALL
GROUND WIRE
(GREEN)
HANGER BRACKET
GROUND WIRE
(GREEN)
HANGER BRACKET
BLACK RECEIVER WIRE
OPEN
PORTION OF
RECEIVER
HERE
Figure 14
Turning off wall switch is not sufficient. To
avoid possible electrical shock, be sure
electricity is turned off at the main fuse or
circuit breaker box before wiring. All
wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a pre-
caution against possible electrical shock.
!
WARNING
How to Wire Your Ceiling Fan
If you feel that you do not have enough
electrical wiring knowledge or experi-
ence, have your fan installed by a
licensed electrician.
1.
Pull the wire leads, coming from the end of
the downrod, and the supply wires through
the open side of the hanger bracket
(Figure 14).
3.
Using wire connectors (supplied), make
wiring connections as follows (Figure 14
and 15):
a. Connect the white fan wire and the
white supply wire to the white receiver
wire (AC IN/ MOTOR N).
b. Connect the black fan wire to the black
receiver wire (TO MOTOR L).
c. Connect the black supply wire to the
black/white receiver wire (AC IN L).
d. Cut off the ends of the blue and yellow
receiver wires and strip back insulation
1/2-inch from the ends of the wires.
e. Connect the blue fan wire to the blue
receiver wire (BOTTOM LIGHT).
f. Connect the yellow fan wire to the yel-
low receiver wire (UPPER LIGHT).
g. Connect the green ground wires from
the hanger bracket and the hanger ball
to the supply ground wire (bare or
green).
CAUTION: To reduce the risk of electri-
cal shock, disconnect the electrical sup-
ply circuit before installing the fan, light
kit or receiver.
BP7288-1 TB301 Paradise Key 1/26/11 11:59 PM Page 10
