Tommy Bahama PARADISE KEY, Руководство пользователя

Страница: 12 / 20

KNURLED
KNOB (2)
CEILING
COVER
1-1/4"
THREADED
STUD
LOCKWASHER
(2)
Figure 17
To avoid possible fire or shock, make sure
that the electrical wire are completely
inside the outlet box and not pinched
between the ceiling cover and the ceiling.
! WARNING
12
7.
Slide the receiver up and over the hanger
bracket. Press the receiver against the ceil-
ing, then slide the ceiling cover up to the
threaded studs and turn until the studs
protrude through the holes in the ceiling
cover (Figure 17).
8. Secure the ceiling cover in place by sliding
lockwashers (supplied) over the threaded
studs and installing the two knurled knobs
(supplied). (Figure 17.) Tighten the knurled
knobs securely until the ceiling cover fits
snugly against the ceiling.
9.
Hold the switch housing cover over the
switch housing and carefully rotate the cover
until the notches on the inside of the cover
engage with the detents on the switch hous-
ing. Then secure the cover in place using two
8-32 x 14mm pan head screws (supplied)
(Figure 18).
10. Position the housing cover trim on the
housing cover so that the two mounting
holes are covered (Figure 19). Then install
the finial nut to secure the trim in place.
8-32 X 14mm PAN HEAD
SCREWS (2)
SWITCH
HOUSING
COVER
SWITCH
HOUSING
Figure 18
11. Your ceiling fan is now installed and wired
to be controlled by your remote control
system.
FINIAL NUT
SWITCH HOUSING
COVER
HOUSING COVER
TRIM
Figure 19
BP7288-1 TB301 Paradise Key 1/26/11 11:59 PM Page 12