Tomberlin E-MERGE 2007, Руководство по обслуживанию

Страница: 80 / 157

79
Charger receptacle removal
1. Take out the key from the ke y switch.
2. Apply the parking brake.
3. Disconnect the battery cable according to the directions.
Please refer to Chapter 1 “Protection for Electrical
Safety”.
4. Remove the red wire and the black wire from the po sitive
binding post on the rear o f charger receptacle.
5. Screw o ff the 4 screws fixing the charger receptacle plate
to the so cket bo ttom and the car bo dy.
6. Remove the charger receptacle retaining plate and charger
receptacle.
7. Check:
Check the receptacle fo r cracks, poor contact and wear
and replace the part if necessary.
Charger receptacle installation:
Back to the removal ste ps
Battery removal
1. Take ou t the key from the key switch.
2. Apply the parking brake.
3. Remove the seat pad assembly
4. Disconnect the battery cable according to the directions.
Please refer to Chapter 1 “Protection for Electrical
Safety”.
5. Remove the nut o n the battery ho ld down.
6. Remove the battery hold down
7. Remove the battery with a special battery lifting too l.
8. Check:
Check the electrolyte level of the battery; add distilled
water to 13mm above the plate electrode if the level is
below the plate electrode.
Battery installation:
Back to the removal steps.
Leve l indicator
Battery ca p
Plate electrode
The level of e lectrolyte
should be at least 1/2”