TOLSEN TOOLS 79991, Инструкция по эксплуатации

Страница: 18 / 24

problem possible Causes probable Solutions
Follow all safety precautions whenever diagnosing or servicing the equipment or engine.
TROUBLESHOOTING 18
Engine stops
when under
heavy load
Engine misfires
Engine stops
suddenly
Engine knocks
1. Dirty air filter.
2. Engine running cold.
1. Spark plug cap loose.
2. Incorrect spark plug gap or
damaged spark plug.
3. Defective spark plug cap.
4. Old or low quality gasoline.
5. Incorrect compression.
1. Low oil shutdown.
2. Fuel tank empty or full of impure or
low quality gasoline.
3. Defective fuel tank cap creating
vacuum, preventing proper fuel flow.
4. Faulty magneto.
5. Disconnected or improperly
connected spark plug cap.
1. Fill engine oil to proper level. Check engine oil before
EVERY use.
2. Fill fuel tank with fresh 87+ octane stabilizer treated
unleaded gasoline. Do not use gasoline with more than
10% ethanol (E15, E20, E85, etc.).
3. Test/replace fuel tank cap. 4. Have qualified technician
service magneto. 5. Secure spark plug cap.
1. Clean or replace element.
2. Allow engine to warm up prior to operating equipment.
1. Check wire connections.
2. Re-gap or replace spark plug.
3. Replace spark plug cap.
4. Use only fresh 87+ octane stabilizer treated unleaded
gasoline. Do not use gasoline with more than 10%
ethanol (E15, E20, E85, etc.).
5. Diagnose and repair compression. (Use Engine will not
start: COMPRESSION RELATED section.)
1. Old or low quality gasoline.
2. Engine overloaded.
3. Incorrect spark timing, deposit
buildup, worn engine, or other
mechanical problems.
1. Fill fuel tank with fresh 87+ octane stabilizer treated
unleaded gasoline. Do not use gasoline with more than
10% ethanol (E15, E20, E85, etc.).
2. Do not exceed equipment’s load rating.
3. Have qualified technician diagnose and service engine.
Engine backfires 1. Impure or low quality gasoline.
2. Engine too cold.
3. Intake valve stuck or overheated
engine. 1. Fill fuel tank with fresh 87+ octane stabilizer treated
unleaded gasoline. Do not use gasoline with more than
10% ethanol (E15, E20, E85, etc.).
2. Use cold weather fuel and oil additives to prevent
backfiring.
3. Have qualified technician diagnose and service engine.
Product doesn’t
have power.
1. Product not plugged in properly.
2. Circuit Breaker tripped.
3. GFCI activated. 4. Product
needs service. 1. Turn off and unplug the product, then plug it back
in again and turn on.
2. Turn off and unplug product. Reset Circuit Breaker.
Plug in product and turn on.
3. Turn off and unplug product. Test GFCI receptacle.
If functioning properly reset GFCI, plug in product
and turn on.
4. Have product repaired.
Product begins
to operate
abnormally.
1. Problem with appliance.
2. Rated load capacity exceeded. 1. Immediately unplug appliance. Have appliance
repaired by a qualified technician, or replace appliance.
2. Lower the number of items plugged into the Generator
to stay within the rated capacity, or use a more powerful
generator.