Plug the power cable into the library and power outlet.
Power on the library using the power button located on the front panel. Check the LCD screen to make
sure the library is receiving power.
When the library has become ready, power on the backup server, if you have not already done so, any
any other devices you may have powered off prior to connecting the tape library.
NOTE
: When the library is powered on for the first time after a new tape drive
installation or replacement, the library will initialize the tape drive. This process can take
a few minutes to complete.
NOTE
: When powering on a parallel SCSI library, the backup system must be powered
off and the library must completely finish the boot process before the system may be
powered on. Otherwise, the library will not be reported to the backup system until the
backup system is rebooted.
Configuring the Network
Configuring the network enables you to monitor, configure, and control certain library functions from the
remote management interface (RMI). By default, the library will request and IP address from a DHCP
server. You can configure the library to use a static IP address. Once the library has an IP address,
you can change the network configuration from the OCP or RMI.
The library supports IPv4 and IPv6. By default, the library is configured to use IPv4, the most common
current version. You can enable IPv6 or both Internet protocols from the OCP or RMI, and then finish
configuring IPv6 from the RMI.
NOTE
: To use the RMI, you must first setup the administrator password using the OCP.
Until an administrator password has been set, you will not be able to login to the RMI.
To find the IP address obtained by DHCP:
1. From the Home screen, press NEXT until the display shows
Status/Information
. Press
ENTER.
2. Press NEXT until the display shows
Network/Information
. Press ENTER.
3. Press NEXT until the display shows the IP address currently assigned.
4. Press CANCEL until the display is back at the Home screen.
To configure an IPv4 address
1. From the Home screen, press NEXT until the display shows
Configuration
. Press ENTER.
2. Press NEXT until the display shows
Configure Network Settings
. Press ENTER.
3. Press NEXT until the display shows
IPv4 Networking
. To change any IPv4 settings, press
ENTER.
4. Press NEXT until the display shows the setting you want to change. Press ENTER to change the
setting. Use the NEXT and ENTER keys to enter numbers. Press ENTER to confirm.
5. Repeat step 4 to configure additional IPv4 settings.
22
Содержание ArGest TGL1800
