Toledo PWi Forging, Руководство пользователя

Страница: 60 / 92

PWi Forging User’s Manual
Doc #17663 Rev A Page
Toledo Integrated Systems
58
Offset Menu (only available when trigger mode is set to Resolver)

The press stroke can be viewed as a 360º circle with the top position at 0º (fully
opened) and the bottom dead center position at 180º (fully closed). When using
resolver triggering for load capture, the offset value allows the resolver position to
be zeroed. The offset can be adjusted from 0º (no offset) to 359º.
Determining the Offset Value needed
1) Cycle the press to the top position. This should be 0º.
2) Subtract the resolver position shown in the total window from 360 to get the offset
value. Refer to the following section to enter the offset.
To change the Offset Value
1) Push to enter change mode. Current setting is then selected.
2) Push or to change the setting, or
Push or to change in a larger increment.
3) Push to accept the change, or push to cancel the change.
After entering the offset value, the resolver position should read zero. If not, re-calculate
the offset value as described above.