5-1
5
．
OPERATION
5.1 Before operating
Please confirm the installation of SD card (Refer to Section 1.5), wiring (Refer to Section 4) before
it operates.
Afterwards, please confirm the various parameter settings (Refer to Section 7).
5.2 Start and stop of record
The record begins when REC button is pushed.
When the record is stopped, the REC button is pushed again, and it Stop key touches on the
confirmation screen.
5.3 Output timing of recorded data to SD card
The timing of output to the SD card depends on the version. The recorded data is erased from the
internal memory at the timing when it is output to the SD card. The output timing is shown below.
Less than Version 2.00
：
(1) When recording stop (SD card inserted)
(2) When SD card removal operation
(3) When the number of files created for each file recording cycle exceeds 50
(4) When an SD card is inserted (when there is record data in internal memory)
Version 2.00 or later
：
(1) When recording stop (SD card inserted)
(2) When SD card removal operation(Not possible in extended security mode)
(3) When an SD card is inserted (when there is record data in internal memory)
(4) Per file recording cycle(When the file recording cycle is 1 day, it is output to
the SD card at 0:00:00 every day. Also, the sub record is the same)
* From version 2.00 onwards, record data is output every file recording cycle.
Therefore, if you move recorded data to the PC during recording, please save
the data currently being recorded in the same folder name. If you don’t do this
operation, you can’t read the recorded file when reading the management file.
- If the overwrite function is OFF and the SD card is not inserted, there is a possibility that recording may be
stopped due to insufficient free space in the internal memory. It is recommended to insert the SD card and
record it
before the SD card has insufficient free space.
- If SD card capacity display became 10% or less, please perform operation for transferring recorded data.
There is a function(internal special relay) to perform DO output when SD card capacity display became
10% or less. For internal special relay, refer to Section 7.27.
［
Caution]