13
DIGITAL TORQUE GAUGE MODEL
ATGE-G
5-3. Fixing ATGE-G on the table to measure
· Take out the display and place ATGE-G on the measuring board with the three-jaw chuck side up.
When measuring an object (other than a screwdriver)
· Before measurement, check that ATGE-G shows 0 on the display. If it is not zero, push clear
key at no load condition and get 0.
· Holding the chuck holder fixed, open the three-jaw chuck and put the object inside.
· Place the object to be measured in the center of three-jaw chuck, while holding the chuck
holder fixed, tighten the chuck.
· Turn on the power of the torque gauge.
· If the counter is 000, the continuous display (RUN mode) is set. If the counter is 001-999,
PEAK mode is set. It works bi-directionally.
· Hold the torque gauge with one hand and rotate the object with the other. Measure the torque
either in RUN mode or PEAK mode.
Object to be measured
Chuck holder
Display
Fix the torque gauge.
Three-jaw chuck
Make sure to hold the chuck holder when rotating the three-jaw chuck.
When measuring a torque screwdriver
· Set the peak measurement mode to (P-2).
· Before setting the screw driver, turn on the power of ATGE and check the display shows “0”.
If it is not zero, push clear at no load condition and get zero.
ATGE-G型 取扱説明書̲CS5.indd 14
ATGE-G型 取扱説明書̲CS5.indd 14
2016/06/06 16:37:27
2016/06/06 16:37:27
