TOHATSU M 40D2, Руководство пользователя

Страница: 67 / 89

INSPECTION AND MAINTENANCE
67
10
ENON00026-0
Note
It is recommended to check chemical
properties of water on which your out-
board motor is regularly used.
If outboard motor is used in salt water,
brackish water or water with a high acidic
level, use fresh water to remove salt,
chemicals or mud from exterior and
cooling water passage after every cruising
or before storing outboard motor for
long time. Before flushing, remove the
propeller and the forward thrust holder.
ENOM00085-F
Flushing attachment
ENOW00922-0
To prevent the engine from starting when
you are near the propeller, remove the stop
switch lock.
1. Tilt down the outboard motor.
2. Remove the water plug from the gear
case, an d scre w in the flushing
attachment.
3. Attach the flushing attachment and
connect a water hose. Turn on the
water and adjust the flow (Be sure to
seal the water inlet and sub water
inlet, located in the gear case with
tape)
4. Put the shift lever in the neutral posi-
tion and start the engine.
Continue flushing the outboard motor
for 3 to 5 minutes at idling.
5. Stop the engine and water supply.
Remove the flushing attachment and
tape. After the flushing, be sure to
reattach the water plug.
1. Flushing attachment (option)
2. Tape
.
1. Flushing attachment (option)
2. Water inlet
ENOM00085-A
Flushing by test tank
ENOW00081-0
Do not start engine without removing pro-
peller, or accidentally turning propeller
could cause personal injury.
CAUTION
WARNING
ENOF01324-0
1
2
ENOF01420-0
1
1
2