58
OPERATION
4. Set the controls the same as for
normal starting (p. 51 – 53,
54 – 56).
Turn the ignition switch key to the
ON position.
5. Set the alternator pulley so the
cutouts are on the right and left
sides of the alternator pulley as
shown. Hook the knot at the end of
the starter rope (accessory) against
a cutout in the alternator pulley,
and wind the starter rope one and a
half turns clockwise along the
groove in the alternator pulley.
6. Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling the rope.
If necessary, rewind the rope and pull
again. If the engine does not start
after several attempts, refer to
TAKING CARE OF UNEXPECTED
PROBLEMS
from p. 107.
KNOT
ALTERNATOR
PULLEY
EMERGENCY STARTER ROPE
EMERGENCY STARTER ROPE
Direction
to pull
Exposed moving parts can cause
injury.
• Do not operate the outboard
motor without the engine
cover.
• Use extreme care when
installing the engine cover.
31ZZ3T120.book Page 58 Tuesday, November 28, 2017 2:50 PM
