TOHATSU 2 Stroke Cylinder Series, Руководство по обслуживанию

Страница: 228 / 268

SECTION 7
7-36
1-/ 2-Cylinder
Test 5 - CD Unit Output Test - Cranking RPM
NOTE
Make sure all electrical terminals are connected
during this test except those that are noted in the
test procedure.
Check for continuity between chassis ground and
the ground connection for the magneto plate, CD
Unit, and ignition coil before conducting the
following procedure.
Reference the following electrical drawings for the
CD Unit Output Test - Cranking RPM:
- Models 2.5 / 3.5 / 5 / 8 / 9.8, 9.9 / 15 / 18, 25 / 30 and 40.
The CD Unit Output Test - Cranking RPM is used to
determine the output voltage, in DVA, from the CD Unit
(1) ,
to the ignition coil (2) while you are cranking the engine.
1. Remove all spark plug leads, and spark plugs (3) .
2. Adjust spark gap tester (1) to 7/16 in [11 mm].
3. Connect each spark plug lead to spark gap tester (2) .
4. Secure spark gap tester to a clean ground on engine block.
T1784
12
12
12
13
T1988A