W W W . T M G I N D U S T R I A L . C O M
P 1 5 / 4 1
T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
11. Move to the front of the tire and hold it with both hands
in the last part of demounting operation to prevent the tire
from falling or rolling away out of control.
4. Turn the chuck clockwise until the tire is completely
mounted.
Mounting Tubeless Truck Tires (Up to 13”)
1. Liberally lubricate the entire inner surface of the rim and
the tire beads. Attach the mounting clamp to the outer rim
flange with the valve at 11 o’clock and the clamp at 12
o’clock.
Ensure that the outer bead moves into the drop center
when the clamp is opposite to the tool.
2. Move the horizontal chuck arm all the way down then
roll the tire on the foot board and hang it onto the mounting
clamp.
3. Lift the horizontal chuck arm and position the mounting
hook or tubeless roller approximately 1/2” (1.5 cm.) to the
inside of the rim edge and approximately 1/2” (1.5 cm.)
away from the rim edge. The mounting clamp should be at
approximately 11 o’clock.
Never use hand pressure to hold the tire onto the rim as
personal injury may result.
Stop the chuck before one complete turn is made to avoid
personal injury or serious damage to the mounting clamp
and/or rim.
Demounting Duplex and Supersingle
Tubeless Truck Tires (Over 13”Wide)
1. Loosen the outer bead of the tire as described previously.
2. For this type of tire it is not possible to demount both
beads at the same time with the disc as described earlier.
