FloppyFlex User Manual Version 2.0 - 22 August 2022
- 20 -
•
STEP 5
–
Install Anti-Skidding Plate
The Anti-Skidding Plate is designed to grip
onto the FloppyFlex body and provide
leverage to install the Compression Support
Frame.
The wings of the metal Anti-Skidding plate
are intentionally flexible and are intended to
facilitate easier installation.
To install the plate, use fingers to unfold the
wings slightly wider than the width of the
FloppyFlex body. Then position the plate so
that the edge of the frame aligns exactly with
the clean edge of the FloppyFlex.
There is a slight lip on the bottom of the plate,
which should overlap the edge of the
FloppyFlex and align with the bottom of the
silicone connector gasket.
Once aligned, push the bottom of the plate
into place, making sure the plate hugs the
body as closely as possible. Use fingers to
squeeze the plate wings onto the FloppyFlex
until they successfully bite into the housing.
Warning
: Improper alignment may result in
the IP67 rating being compromised. Water
ingress failure due to incorrect assembly is
not covered by warranty.
•
STEP 6
–
Install Compression Support
Frame
The Compression Support Frame is a strong
metal support designed to interface with
strength member points on the Anti-Skidding
Plate and connector to effectively lock the
connector onto the FloppyFlex end. It
ensures the completed assembly cannot
easily be removed.
Align the frame so that the “U” cutout faces
the connector side.
Slide the frame over both the connector and
Anti-Skidding Plate and apply even pressure
until the plate is flush along the bottom of the
plate and connector with no gaps around the
frame.
Note
: The Compression Support Frame is
intended to fit tightly. Installing the Frame
correctly may sometimes require additional
force on the connector to push it towards
FloppyFlex end until the frame can snap into
place.
