TLV PowerTrap GP10L, Инструкция по эксплуатации

Страница: 9 / 36

172-65043MA-02 (GP10L/GT10L PowerTrap ) 9 Mar 2004
8
Installation
DO NOT use this product outside the recommended operating pressure,
temperature and other specification ranges. Improper use may result in
such hazards as damage to the product or malfunctions which may
lead to serious accidents. Local regulations may restrict the use of this
product to below the conditions quoted.
CAUTION
Use hoisting equipment for heavy objects (weighing approximately
20 kg (44 lb) or more). Failure to do so may result in back strain or other
injury if the object should fall.
CAUTION
Take measures to prevent people from coming into direct contact with
product outlets. Failure to do so may result in burns or other injury from
the discharge of fluids.
CAUTION
Do not use excessive force when connecting threaded pipes to the
product. Over-tightening may cause breakage leading to fluid
discharge, which may cause burns or other injury.
CAUTION
Use only under conditions in which no water hammer will occur. The
impact of water hammer may damage the product, leading to fluid
discharge, which may cause burns or other injury.
CAUTION
Open System Piping
[Ci]
[Vo]
Condensate
Recovery
Line
Primary
Pressure for
Motive
Medium
Motive
Medium
Supply
Pressure
[Pm]
Pump Exhaust
[Co]
Steam Using
Equipment
Condensate
Receiver
[Ve]
[Vi]
Back
Pressure
[Pb]
Steam Trap
Flash Steam
Temperature
Controller
Steam
Trap
Overflow
Other Steam Using
Equipment
Filling Head [A]
[D]
Sm
Sv
Se
Si
So
Sr
Maximum
Equipment
Pressure
[P1]
Steam
for
Heating
Condensate
Supply
[Q]
Pipe the discharge to a safe area such as a pit.
[Ki]
[Rm]
[St]
TLV
GP
Steam Trap
Backflow Water Hammer Prevention Check Valve
[Km]
[Vm]
M
a
xi
mu
m H
e
ig
ht
: 3m (
10 ft
)
When the rise in piping is 30 m (100 ft) or farther from the
PowerTrap, installation of a check valve is recommended
for the prevention of return water hammer.
Pipe the discharge to a safe place such as a pit.
Note: This sketch is for explanation purposes only
and is not intended as an installation design.
Q Condensate Supply Se Exhaust Pipe Rm Motive Medium Pressure
A Filling Head Sv Vent Pipe Reducing Valve
Pm Motive Medium Supply Pressure Dh Condensate Receiver St Steam Trap on Drip leg
Pb Back Pressure GP PowerTrap Vi Valve on Condensate Inlet Pipe
Si Condensate Inlet Pipe Ci Condensate Inlet Check Valve Vo Valve on Condensate Outlet Pipe
So Condensate Outlet Pipe Co Condensate Outlet Check Valve Vm Valve on Motive Medium Supply
Sr Condensate Recovery Line Ki Condensate Inlet Strainer Pipe
Sm Motive Medium Supply Pipe Km Motive Medium Strainer Ve Valve on Exhaust Pipe
Back
Pressure
[Pb]
[Dh]
TLV
GP