TLV JL14-X, Инструкция по эксплуатации

Страница: 14 / 19

172-65441A-04 (JL14-X/JLH14-X/JLH14-B) 20 Jan 2021
13
Detaching/Reattaching the Lever Unit & Float Unit
Part During Disassembly During Reassembly
Lever
Unit
Trap Unit -Remove the split pin from
each end of the main joint
stem
-Loosen with a wrench
and remove the U-nut
use for the joint bolt
-Pull out the main joint
stem
-Pull out the joint bolt,
paying attention to the
position of the flats on the
joint bolt; the lever unit
and the trap unit can then
be separated
-Ensure proper orientation for the lever unit at
reassembly;
Connect the lever unit to the trap unit with the
“UP”
mark facing upwards
-Referring to the figure below, insert both the main
joint stem and the joint bolt; remember to reinsert the
washers; once a new split pin is inserted into each
end of the main joint stem, make sure to bend both
ends of each split pin so it does not come off
-The flats on the joint bolt should be positioned as
shown in the figure below; remember to reinsert the
washers; make sure the flat surface of the U-nut is
facing the washer at reassembly; consult the table of
tightening torques and tighten to the proper torque
“UP” mark
facing upwards
Make sure to insert a
split pin into each end of
the main joint stem and
bend the ends up at time
of assembly
Split Pin
Washer
U-nut
Washer
Split Pin
Joint Bolt
Main Joint Stem
Washer
Washer
Trap Bar
Make sure the flat
surface of the U-nut
is facing the washer
at time of assembly
Pay attention to the position
of flats on the joint bolt at
time of assembly
Flat
surface