Disassembly/Reassembly
(to reassemble, follow procedures in reverse)
JH3X JH5RL-X JH7RL-X JH7.2R-X
Part & No.
JH7.5R-X JH8R-X
Use a wrench to
remove
Remove gasket and
clean sealing surfaces
Remove gasket and
clean sealing surfaces
Use a wrench to
remove
Remove gasket and
clean sealing surfaces
Use a wrench to
remove
Remove gasket and
clean sealing surfaces
Use appropriate pliers,
squeeze and remove
Remove from the guide
or case
Use a wrench to
remove
Lift straight up
while turning
Use a wrench to
remove
Remove gasket and
clean sealing surfaces
Use a wrench to
remove
Remove the connector
Use appropriate pliers
Use appropriate pliers
Lift straight up
Remove
Remove screen
Lift up and off (use all
four eyebolts for
JH8R-X)
Remove, being careful
not to scratch its
polished surface
Disassembly
Reassembly
*
*
*
*
**
**
**
**
**
**
**
**
**
**
**
**
***
***
***
***
***
***
***
***
***
***
Coat threads with anti-seize
and tighten to the proper torque
Place screen holder on ledge
inside body, round side up;
place screen holder retainer
next (if applicable), followed by
screen
Coat threads with anti-seize and
tighten to the proper torque
Insert screen securely
Fix with Air Vent Valve Seat
Insert securely into groove
Cover 2
Cover Gasket 3
Connector 12
Connector
Gasket 13
Drain Plug 21
X-element
Case 27
X-element Case
Gasket 30
Snap Ring 25
Spring Clip 17
(X-element)
X-element 14
Air Vent Valve
Seat 16
X-element
Guide 15
Screen 9 &
Float Cover 20
Screen Holder 23
Float 4
Outlet Cover 7
Plug or Outlet
Cover Gasket 8
Orifice 5
* Option
** The entire unit may be removed and replaced at the X-element guide 15 with an open wrench.
*** Must remove X-element Case 27 before this part can be removed or inserted
Remove gasket and
clean sealing surfaces
Orifice Gasket 6
Remove without
bending
Remove without
bending
Align the cover with the
connector or the arrow on the
body and attach
Replace with a new gasket, do
not apply anti-seize
Replace with a new gasket, do
not apply anti-seize
Coat threads with anti-seize
and tighten to the proper torque
Replace with a new gasket,
coat surfaces with anti-seize
Coat threads with anti-seize
and tighten to the proper torque
Replace with a new gasket,
coat surfaces with anti-seize
Align arrows and insert, insert
tab on bottom into guide on
body and push in until top is
flush
Insert into body, being careful
not to scratch its polished
surface
Squeeze and insert securely
into the groove
Make sure the X-element is not
upside down
Coat threads with anti-seize and
tighten to the proper torque
Replace with a new gasket,
coat surfaces with anti-seize
Coat threads with anti-seize and
tighten to the proper torque
Insert the connector
Insert securely into groove
Attach
Cover Bolt 10
Cover Nut 11
X-element
Screen 28
Snap Ring 24
Screen 9
Screen Holder
Retainer 26
Orifice Plug 7
Outlet Cover Nut 32
Replace with a new gasket,
coat surfaces with anti-seize
Drain Plug
Gasket 22
̶ 10 ̶
English
