TLT-Turbo GmbH
Installation, operating and maintenance instructions.
For axial flow fans
Page 12
Series fan division
Bad Hersfeld
Type AXO ... / ...
of 12
MBW-AXO.DOC
Issue: 03.2004
16. Spare part stockkeeping
Spare and wear parts with long delivery time should be stocked by yourselves.
Production loss usually is more expensive than the cost of the part. (Please request
the spare and wear parts list seperatelylook into the spare and wear parts list in the
annex; please request separately).
We would like to point out particularly, that spare parts not supplied by us are
were not checked and released by us. The manufacturer shall not be liable for
damages caused by the use of not original parts and accessories.
If you have questions please contact our field staff or the specialists in our
Bad Hersfeld plant.
17. Annex
Assembly of the impeller
Slightly grease the end of the shaft. Then mount
the wheel using a special fitting too.
(Threaded hole in the face of the shaft according to
DIN 332)
Make sure that the impeller does not slide along
parts when turning it by hand. The required air gap
between the tip of the blade and the duct wall is
listed in the air gap chart.
Finally the wheel is secured on the shaft using the
enclosed parts ( thrust disk
n
, hexagonal screw
o
,
seal
p
and mounting screws
Heat class
Roller bearing grease
Application
B
Lithium soap roller
-35° C - +140° C
bearing grease K3K DI 51825
F
High-temperature long-life
-35° C - +155° C
grease
short time 200° C
H
Long-life grease on
-25° C - +210° C
synthetic oil basis
For motors which are used for special operating conditions
the grease types used and the regreasing dates
are marked on a special indication plate on the motor
