TLS QuickScout A/D XL, Инструкция по установке и эксплуатации

Страница: 30 / 52

Operating instructions
30 As of 06/13
Enable complement reset
This operation mode
must be activated in TLS QuickScout A/D XL
in order to process the switching between the signal sources
properly.
Warning: At a QuickScout AD system with several devices only
one device may have this function activated.
Enable power save modus
In this operation mode the TLS QuickScout A/D XL is set into an
energy saving mode after 10 s without any function. As soon as there
is a signal again, or a button is pressed, the device will leave the
energy saving mode.
Enable digital signal amplifying circuit
In this operation mode the integrated amplifier for digital video signals
gets activated. You need this operation mode, if you use very long
HDMI or DVI cables to the signal inputs. For information regarding
the admissible cable lengths with TLS digital cables, please refer to
the following cable matrix:
http://www.tls-gmbh.com/HDMI.804.0.html
Enable device is on last place
This operation mode must be selected at last QuickScout device of a
QuickScout system . The last device is the one, which is nearest to
the diplay device.
A single TLS QuickScout A/D XL must be always last place
.
Thereby the last device is able to decouple the control signals from
the video lines and to process them accordingly.