TLS QuickScout A/D XL, Инструкция по установке и эксплуатации

Страница: 19 / 52

Operating instructions
As of 06/13 19
C 4.9 Connecting Control output
Control
C
If you would like to control
TLS QuickScout A/D XL externally, you
can connect an external control via the 2 pin Phoenix connector
Control . The TLS QuickScout A/D XL system recognises the
pressing at select buttons for analogue or digital video signals and
reports this on both outputs Control in the analogue or digital field.
The external control can evaluate this information and selects at the
display device the input required for the system.
As the Control connection is bi-directional, the external control can
also execute the
„complement reset function“(page 33). For that the
external control must close the contact for more than 200 ms. If the
contact gets closed for more than 5 s, the
TLS QuickScout A/D XL
gets switched off.
In addition the external control, e. g. die
TLS GlobalControl , can
execute further control tasks and even send SMS and Emails resp.
respond to incoming messages. Also the control via a browser
interface or a
TLS Touch panel is easily possible.
For this connect the ground potential 0V with the ground potential of
the external control and each of the two signal contacts C with an
input of the external control.
C 5 Initial operation
After having connected TLS QuickScout A/D XL to the power
supply, you must press any Select button to switch on the device.
Now the corresponding Select LED lights up red. The device is now
ready for operation.
When using a HDMI notebook: Connect your notebook with a
HDMI/HDMI cable to the TLS QuickScout A/D XL at the female
connector HDMI 1 or HDMI 2 (sketch 1, page 9).