TLA Tuning-Set CTS-32-C, Руководство пользователя

Страница: 23 / 39

16
For fine adjustment use the "Value " buttons. For rough adjustment, you hold the "Shift" button and
tap one of the keys "Value ". Pressing both buttons, "Value" at the same time, starts an automatic
scan. The audible tone can also be used. Press "Enter ".
Play the specified note (for the
moment again a_1, since you now
measure the 3rd partial of a-1 and
align the tuner again. Press "Enter".
Play the specified note (for the
moment again a_1, since you
now measure the 4rd partial of a-
1) and align the tuner again.
Press "Enter".
Then press "Enter". The tuner will now continue to the next note. It then emits a short beep
and for 1 second „next note“ is indicated on the display.
Play the specified note (for the
moment again a_2, since you now
measure the fundamental tone of
a-2) and align the tuner again.
Press "Enter".
Certainly, you now know how the device pretends the operating steps. Now perform all meas-
urements.
Important note: When the instrument is grossly out of tune, immediately after the tuner changes
the note, you should align the strings of the actual note with the tuning hammer to the tuner. This
is necessary because the inharmonicity of the piano string depends on its tension. This, however,
only be carried out immediately after the change of tone. So just before the measurements 5 / 9 /,
13 / and 17/
After the last measurement you get
this display. This are eight cents-
values (support values), that were
determined automatically on the
basis of previous measurements.
Press „Enter“. The device calculates the piano stretching and stores them. To start with the real
work of piano tuning, search the function "tune" with the "function" buttons. Then it goes on, as
described in Section 2.2.1.1.
Note: Within the “pianyzer”- procedure, you can use the "special" buttons for back steps.
2.3.6 How to produce a piano stretching by entering of support values (Piano Editor)
The tones with the cent's for calculating the stretching, the sake of simplicity, will be referred to
as "support note". Using the piano editor, the cents of the support-notes, you can enter by hand,
rather than be determined by the analyzer (see sample diagram at the end of the chapter).
Note: The piano editor allows you to edit the cents of the supporting notes, which were previ-
ously generated by the piano analyzer.
+ **
0.0 cent (01/P3) CENTS 3.5 a-1
+ ***
0.0 cent (01/P4) CENTS 6.0 a-1
+ ***|
0.0 cent (01/P4) CENTS 6.0 a-2
-29.5 -12.3 -6.7 -2.8
00.0 03.0 10.0 28.5