TKH
TKH Security | Siqura SA FIX Series |
Installation manual
5
Installing the Camera
Prior to installation and operation, carefully read all instructions the in this manual and
heed all warnings.
Unpack this equipment and handle it carefully. If the package appears to be damaged,
notify the shipper immediately.
Use the original packaging to transport the unit. Disconnect power supply before
moving it. In case of returning the equipment, the original packaging must be used.
Make sure that the installation surface can support at least four times the weight of the
unit in normal operating conditions. In case of excessive external stress (e.g. vibration,
strong winds or impact), the equipment may need additional means of protection.
Proper stainless steel hardware should be carefully chosen to fasten the unit to the
surfaces.
Use caution when lifting and assembling the unit. It is recommended that non-slip
protective gloves be worn during installation. The unit could bear sharp edges.
Trying to manually force the wiper will result in damaging the device and will void the
warranty.
To maintain the IP rating of the unit, adequate cable glands must be used. The unit
must be tightly closed when operating.
WARNING: The device is equipped with remotely controlled moving parts.
For security reasons, do not install the unit in the proximity of water containers and
never push objects or pour liquids into the unit. The unit can be safely used in damp
environments or outdoors, as long as the connectors are properly sealed.
Video and data cables should not share the same conduit with supply voltage cables.
Whenever EMC is an issue, adequately shielded cables must be used.
Open only the covers pointed out in this installation manual. Other covers should be
open only by the manufacturer.
After the installation of the unit, the desiccant bag must be placed inside the unit,
assuring it won't be damaged by rotating and moving parts.
WARNING: The heating element may still be hot for some time after switching off the
power.
Remove the protective PVC sheet from the sunshield.
This equipment has been designed to fit in harsh environments requiring little or no
maintenance. Suggested inspection interval is 6 months, but extremely harsh
environments may require more frequent inspection and maintenance checks. On
each inspection check the O-ring seals and the eventual window wiper blade integrity.
Replace them if necessary.
Check cables, electrical connections and mounting hardware for integrity and
tightness. Replace or tighten any damaged/loose part.
Before performing any operation, turn off the power. The installation of the unit can be
performed only by qualified personnel in accordance with the regulations in force. Do
not connect the unit to a supply circuit unless the installation is completed.
Check carefully the supply voltage marked on the label. Incorrect Power Supply
Voltage may damage the unit. Do not overload the terminal connection, as it may
cause a fire or electrical shock hazard.
An all-pole mains switch with an opening distance between the contacts at least 3 mm
in each pole must be incorporated in the electrical installation. The switch must be
equipped with protection against the fault current towards the ground (differential) and
