TJM Pro Series Single Air Compressor: Installation and User Manual
For product warranty please refer to our website www.tjm.com.au
File: F-17800
Page 5 of 19
10/12/2021
2.0
Compressor Assembly
2.1
Accessory Installation
The 12 V solenoid shown is supplied with the TJM Pro Locker. The ¼” BSPT hose fitting shown is supplied
with the TJM Airline Kit, TJM Bulkhead Fitting Kit, TJM Fascia Panel Mount Kit or Bulkhead Fittings kits
which can be purchased separately.
3 x
⅛” and 1 x ¼” ports shown.
Additional ports on opposite side of air tank.
o
Determine the desired mounting
configuration for the compressor and select
the desired outlet ports for the accessories
–
there are 8 available outlet ports in total.
o
To fit the Pressure Switch and Pro-Locker
solenoids, remove one of the
⅛”
BSPT plugs in
the air tank using a 5mm hex key.
o
To fit the TJM Airline Kit, remove one of the
¼”
BSPT plugs in the air tank using a 6 mm
hex key.
o
If necessary, remove the safety relief valve to
provide space for the accessory fitment.
o
Apply sealant paste (e.g. Loctite 567) or
sealant tape to one end of the threaded
fitting of the accessory.
o
Insert accessory into the air tank port and
tighten.
o
Recommended installation positions are
shown in the figure.
o
If the safety relief valve was removed, apply
sealant paste or sealant tape and re-install
the valve to the same port.
o
If using a thread sealant allow curing time
according to the manufacturer specification
NOTE:
DO NOT over-tighten, may cause damage to thread.
1/4
” BSPT
