20
Adjusting the riveting tool
19
15
The adjustment to another working stroke follows on the underside of the
riveting tool. For this you need the spanner for internal hex key SW4 (19).
Note
The stroke is approx. 9.0 mm when the stroke adjustment
screw (15) has been screwed out to the limit by left-handed
rotations
• Check if the compressed air hose is connected. If not, connect the
compressed air supply.
Using the spanner for hexagon nuts SW4 (19) turn the stroke adjustment
screw (15) in the relevant direction:
— right “-” reduce the stroke
— left “+” increase the stroke
Note
Four turns of the stroke adjustment screw (15) correspond to a
stroke adjustment of 1 mm
Attention
Material damage! If you do not know the stroke setting,
unscrew the adjustment screw (6.1) a few turns (ca. 5 mm) for
the automatic switch over to the left-handed rotation. This is to
ensure that the piston will not hit the back and the riveting tool
will not be damaged.
You must now measure the stroke (H) (see page 21).
E
6.1
