©2012 Toni Clark practical scale GmbH Zeiss-Str.10 D-32312 Lübbecke Tel. 0049 5741/5035 Fax. 05741/40338 www.toni-clark.com
Instructions Titan ZG 45PCI-HV
11
Fuel tank connections
Make two air vents made with fuel tubing, fitted to two single sided nipples in the
tanks topside, central at the rear end. These two air vent lines must be led forward
over the tank and then down into the fuselage floor at the cooling air outlet of the
engine cowling. One of these vent lines (does not matter which) is used to fill the tank.
These two lines are always shut off, with two 3,5 mm self tapping screws 15 mm long
with heads removed, while the model is flying or otherwise parked.
Because the threads are so coarse, enough
air can enter the tank, but even during
violent stunting no fuel will be lost. The
saving in fuel is considerable! This system
is simple and 100% reliable, also during filling the tank, you will not spill fuel over your
model. The double sided tank nipple from the clunk filter is best placed in the middle
of the tank cap.
