Titan TTB336TCB, Инструкция по безопасности и эксплуатации

Страница: 15 / 19

TITAN TILE CUTTER 500W TTB336TCB
Fig 17
3. OPERATION
FILLING THE WATER TANK
Before cutting, the tank must be filled with water:
- Unplug the tile cutter from the mains supply.
- Remove the cover from the working table.
- Fill the tank with water in order to just cover the
disc edge (ensure that no more than ¼ of the disc
is submerged in water).
- When you have finished cutting, remove the plug
inside the tank to drain the water(Fig 17).
WARNING: Do not add chemicals or detergents
to the water.
CONNECTION TO THE ELECTRICAL
SUPPLY
Before switching on, make sure that the voltage of
the mains supply is the same as indicated on the
rating plate. This product is designed to operate
on 230-240V~50Hz. Connecting it to any other
power source may cause damage.
This appliance must be earthed. If in doubt, please
consult a qualified electrician.The mains supply
shall be fed via a 10 fuse min.
This machine must be supplied through a residual
current device (RCD).
Put the tile cutter on a clean, stable and flat surface.
WARNING! Before switching the tile cutter
on, make sure that you have read and
understood all of the safety instructions. Make sure
also that the machine has been correctly assembled
and adjusted. Make sure that the mains is
disconnected from the supply when the tile cutter
is not being used or adjustments are being made.
WARNING! This machine must be supplied
through a residual current device (RCD).
- Plug the mains cable into the mains supply.
- Fill the water tank . Press the green switch marked I.
- The machine will now start. Always allow the disc
to reach full speed before performing any cutting
operations.
- To switch off the machine, push the red switch
marked 0. The tile cutter will now stop.
WARNING! The disc will continue to rotate
for a few seconds after the machine has been
switched off. Wait for the disc to stop before removing