Titan TTB336TCB, Инструкция по безопасности и эксплуатации

Страница: 16 / 19

MAKING A STRAIGHT CUT
Adjust the parallel guide to the desired width. Use
the securing knob to loosen or adjust the guide.
Position the tile firmly against the parallel guide
and through the blade in a smooth action.
Hold the edges of the tile and press down firmly
to prevent the tile lifting during the cut.
MAKING A MITRE OR DIAGONAL CUT
Follow the same procedure for a straight cut but
use the mitre cutting guide in conjunction with the
parallel guide.
The mitre cutting guide simply clips onto the
parallel guide.
Make sure that the tile is held firmly in the guide
before making the cut.
CUTTING AN ANGLE OR BEVEL
Use the 45° vertical fence if you wish to cut an
angle or bevel on the tile edge. lift the 45° vertical
fence inserting
the plastic tabs into the corresponding holes on the
table.
Then make the cut as before.
Internal or external bevel cuts can be made by
turning the
tile face up or down (internal - eg.wall corner;
external - eg. window reveal).
the workpiece or making any adjustments.
Stop the machine immediately if there is undue
vibration or some other fault. If this situation
continues, check the machine to find the origin of
the fault.