7. Operation
-----------------------------------------------------------------------------------------------------------------------------------------
05
06
7.
Move the choke lever to the ON position
(03). And pull out the starter rope quickly to
restart engine.
8.
Allow the engine to warm up for several
minutes before starting operation.
NOTE
1.
When restarting the engine immediately
after stopping it, leave the choke ON (03)
2.
Overchoking can make the engine hard to
start due to excess fuel. When the engine
failed to start after several attempts, open
the choke and repeat pulling the rope, or
remove the spark plug and dry it.
■
STOPPING ENGINE
1. Release the throttle lever and run the engine
for a half minute.
2. Shift the ignition switch to the STOP position.
NOTE
• Except for an emergency, avoid stopping the
engine while pulling the throttle lever.
■
ADJUSTING IDLING SPEED (06)
1. When the engine tends stop frequently at
idling mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after
releasing the trigger, turn the adjusting screw
NOTE
• Warm up the engine before adjusting the
idling speed.
■
DRILLING
•
Keep a firm grip of the auger at all times on a
wide stance and by holding the handle with both
hands.
•
A reacting motion may occur on the auger
when spinning driller has hit on stones or tree
roots under the ground. Always hold the auger
securely to control such motion.
•
Start drilling with half-throttle, and gradually
increase the engine speed so that the driller may
get into the ground smoothly.
•
When the drill has been caught in the ground
and cannot be pulled out, stop the engine and
rotate the auger counter-clockwise.
