7. Operation
-----------------------------------------------------------------------------------------------------------------------------------------
01
02
03
04
■
INSTALLING DRILLER (01)
1.
Insert the driller (A) on the drive shaft (B).
2.
Connect the driller (A) using the screw (C)
and with the drive shaft (B) of the gearcase
and screw it with the nut (D).
■
STARTING ENGINE
WARNING
The driller will start rotating upon the engine
starts.
1.
Feed fuel into the fuel tank and tighten the
cap securely.
2.
Rest the unit on a flat, firm place. Keep the
driller off the ground and clear of
surrounding objects as it will start rotating
upon starting of the engine.
3.
Push the primer pump several times until
overflown fuel flows out in the return tube.
(02)
4.
Move the choke lever to the OFF position.
(03)
(1) Choke lever (2) OFF position
(3) ON position
5.
Set the ignition switch to the “start” position.
While pulling the throttle lever, push the
throttle set button, and release the throttle,
then the throttle lever is into the “Start
position. (04)
(1) Ignition switch (2) Stop
(3) Start
6.
While holding the unit firmly, pull out the
starter rope quickly until engine fires. (05)
IMPORTANT
• Avoid pulling the rope to its end or
returning it by releasing the knob. Such actions
can cause starter failures.
