Version 2.01 TS132/TS142/TS152 QIG
TRANSMITTER
LEARNING
Important!
The remote starter will hold 4 transmitter codes. It is
recommended that when programming in transmitters, you fill up all four
transmitter codes, even if only using one or two transmitters. This will
clear all other transmitter coding from the unit and prevent stray coding
or possible interference from other remote transmitters.
a.
Turn ignition ON
±
OFF
±
ON
±
OFF
±
ON.
b.
Press the valet switch (button) in the antenna and hold on, siren/horn (optional) will
chirp once, the LED will turn on constantly.
c.
Keep on holding the valet switch, siren/horn will chirp 5 times to indicate you have
entered transmitter learning mode.
d.
Press button 1 (Lock) of every transmitter to be coded. The siren/horn will chirp once
and the parking lights will flash once to indicate successfully learning. If only using
only 2 transmitters, code in each transmitter twice.
e.
Up to 4 transmitters can be learned to each unit, each transmitter must be finished in 8
seconds.
f.
Turn ignition OFF and the unit will exit code-learning mode. You will hear one long
siren/horn chirp to confirm.
V
ALET MODE
a.
To activate Valet mode, turn ignition ON. Within 10 seconds, press and hold the valet
switch for 5 seconds. Parking lights will flash once and siren/horn will chirp 5 times to
enter VALET mode. LEDs in the antenna will be constantly ON when the ignition is
OFF. When Ignition ON, the LED will turn off.
b.
In valet mode, the system can
¶
t be armed or remote started, however lock and trunk
functions will still operate. If you attempt to start the vehicle in valet mode, the unit
will not start and you will get 3 long flashes from the park lights.
c.
To disable valet mode: turn ignition ON. Within 10 seconds press and hold the valet
switch for 5 seconds. LED will turn OFF, siren/horn will chirp and parking lights will
flash twice to indicate exiting valet mode.
