Titan TM45FG, Руководство по эксплуатации

Страница: 20 / 31

TOOL CHANGING
(1)
The tail of twist drill insert into the flat slot in the spindle
hole, check the drill installation then start operation.
When removing the twist drill, put the small end of tool back
wedge to the top of tail in the spindle tool back hole from tool
back hole lies in the right side of spindle sleeve, hole the drill with
left hand then knock the big end of tool back wedge lightly, tool
will be taken out. Do not drop the tool on the table or work
piece.
(2)
Installation of reamer and boring tool are same as above.
(3)
When installing the drill less thanφ13，install he drill
chuck onto the spindle hole first, steps are same as above. Then
loose drill chuck, put the drill shank into the drill chuck and
tighten up. Make sure the fix installation then start drilling.
(4)
Mills installation and removement
a.
Install the mill or mandrel and draw bar onto the spindle,
tighten up the draw bar and mill or mandrel. Note not too tight.
b.
When removing the mill, use the spanner to loose draw
bar about two circles, knock it lightly with hammer then hold
the tool with one hand and take away the draw bar with
another hand.