![background image](http://html1.mh-extra.com/html/titan/powrmax-605/powrmax-605_operating-manual_1119458015.webp)
15
COMMISSIONING
PowrMax
6.7
PREPARING THE MORTAR SPRAYING
MACHINE (FIG. 12)
RECOMMENDED SLIDING MEANS FOR THE MORTAR HOSE
Attention
Water is not sufficient as a sliding means.
Danger of clogging!
Use cellulose paste
1. Fill 2–3 l cellulose paste into the container.
2. Connect the mortar spraying machine to the mains supply.
The operation light (1) shows operational readiness.
Risk of injury from escaping material.
Before switching on, always check that the
material tap on the spray lance is closed (material
tap points forwards).
Close material tap whenever stopping work.
3. Set selector switch (2) to “A”.
4. Set delivery volume controller (3) to „3“.
1
2 3
6.7.1
RINSE THE MORTAR HOSE
1. Close the air flow regulator (fig. 13.3).
Attention
Do not bend the mortar hose!
Protect it against damage, for example against
being driven over as well as against sharp objects
and edges.
2. Hold spray lance over an empty bucket.
3. Open material tap (Fig. 13, 1) on spray lance (material
tap at 90° to spray lance), the mortar spraying machine is
switched on.
4. If cellulose paste comes out of the tip, close the material
tap (fig. 13, 1) (material tap points forwards).
5. Fill coating material into the receptacle.
i
With mineral coating materials only fill the
receptacle to half full.
6. Position the spray lance over the bucket again.
7. Replace container and lubricant with container and
coating material.
8. Hold spray lance above container with cellulose paste.
9. Open material tap (Fig. 13, 1) on spray lance.
10. As soon as coating material exits from spray lance, close
material tap (Fig. 13, 1).
The mortar spraying machine is now full and ready.
1
3