16
BLEEDING
35) Next, move the target and place it at point “B” on the runway. (See Fig. O)
36) Rotate the Level and focus on the target scale.
37) Adjust the adjustment nut on the safety ladder bar at the top of the Column at “B” until
the cross hair of the Level align to reference mark on the target scale. (See Fig. O)
38) Repeat steps locating the target assembly at points “C” and “D” and adjusting safety
ladders at each corresponding column until the reference mark on the target scale is on
the cross hair of the Level. The runways are now level at all four points.
Fig. O
39) To complete the leveling procedures, TIGHTEN EACH SAFETY LADDER TOP NUT
against the bottom of the Column Top Plate. Torque to 35-45 ft. lbs.
40) Next, load vehicle onto the lift.
41) Raise the lift to full height. Listen and watch as the locking latches click in place.
SYNCHRONIZE BY ADJUSTING THE CABLES so that all four latches click at the same
time. Make necessary adjustments to the cables allowing COMPENSATION FOR
STRETCH.
42) Lift must be fully lowered before changing or adding fluid.
43) Raise and lower lift six times. The cylinder is self-bleeding. After bleeding system, fluid
level in power unit reservoir may be down. Add more fluid if necessary to raise lift to full
height. It is only necessary to add fluid to allow full height raise.
44) To pressure test, run lift to full rise and run motor for approximately 3-seconds after lift
stops. This will place pressure on the hydraulic system. Stop and check all fittings and
hose connections. Tighten or reseal if required.
Содержание HD4P-12000
