Titan HD4P-12000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 44

13
15) Make sure the POWER UNIT RESERVOIR is full. Fill the oil tank with a premium quality
ISO-32, AW-46 Hydraulic Oil.
16) Spray a light lubricant to the inside and outside of the columns where the slide blocks
glide.
17) Test the power unit by pressing “UP” button. If the motor sounds like it is operating
properly, raise the lift and check all hose connections for leaks. If the motor gets hot or
makes unusual sounds, stop and check all electrical connections.
18) Before proceeding, double-check to make sure all cables are properly positioned within
the grooves of ALL sheaves. Make sure all cable sheave retaining pins and/or clips are
secure.
19) Check to make sure that all slack safety locks are cleared and free.
20) Continue pressing the “UP” button until the cables get taught and the lift starts to
move.
21) RAISE LIFT UNTIL THE CYLINDER BOTTOMS OUT AND THE LIFT STOPS. ADJUST
EACH CABLE SO THAT EACH SAFETY LOCK RESTS ABOVE THE TOP SAFETY LOCK
POSITION. It may be necessary to tighten or loosen each cable to reach the proper
height. The cable nuts MUST be tightened until there is at least one inch of threads
protruding through the nut.
ANCHORING THE COLUMNS
22) Before proceeding, DOUBLE CHECK MEASUREMENTS and make certain that the bases
of each column are square and aligned with the chalk line. Raise the lift up and down
and make sure it operates properly at the locations prescribed by the markings on the
floor. (See Fig. H)
Fig. H
Fig. I
23) Using the BASE PLATE on each column as a guide, drill each
anchor hole approximately 5” deep using a rotary hammer
drill and 3/4” concrete bit. ( See Fig. I)