EN
20
In
more
detail...
TTB926STM
by TITAN
EN
Care and maintenance
Power cord
If the power cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a safety hazard.
UK plug
If you need to replace the fitted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Blue – Neutral
Brown – Live
Green/Yellow - Earth
As the colours of the wire in the mains lead of this product may not correspond
with the coloured marking identifying the terminals in your plug, proceed as
follows. The wire, which is coloured blue, must be connected to the terminal,
which is marked with N or coloured black. The wire, which is coloured brown,
must be connected to the terminal, which is marked L or coloured red. The wire,
which is colored green/yellow,must be connected to the terminal, which is mark
E or .
WARNING!
Never connect live or neutral wires to the earth terminal of
the plug, which is marked with E.
If you need to replace the fitted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Blue – Neutral
Brown – Live
Green/Yellow - Earth
As the colours of the wire in the mains lead of this product may not correspond
with the coloured marking identifying the terminals in your plug, proceed as
follows. The wire, which is coloured blue, must be connected to the terminal,
which is marked with N or coloured black. The wire, which is coloured brown,
must be connected to the terminal, which is marked L or coloured red. The wire,
which is colored green/yellow,must be connected to the terminal, which is mark E
or .
Only fit an approved BS 1363 or BS 1363/A plug and correctly rated BS 1362 13
Amp fuse. If in doubt, consult a qualified electrician.
UK plug
.
WARNING!
Never connect live or neutral wires to the earth terminal of
the plug, which is marked with E.
NOTE:
If a moulded plug is fitted and has to be removed take great
care in disposing of the plug and severed cable, it must be destroyed
to prevent engaging into a socket.
firmly clamped
13 AMP fuse approved
to BS 1362
Brown L (Live)
Cable grip
Outer sleeve
Connect Blue to N
Connect green/yellow wire
to E (Protective earth)
(Neutral)
Only fit an approved BS 1363 or BS 1363/A plug and correctly rated BS 1362 13
Amp fuse. If in doubt, consult a qualified electrician.
NOTE:
If a moulded plug is fitted and has to be removed take great
care in disposing of the plug and severed cable, it must be destroyed
to prevent engaging into a socket.
General cleaning
NOTE:
Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
2. Check for worn or damaged parts. Replace worn parts as necessary or
contact an authorised service centre for repair before using the product again.
Maintenance
Before and after each use, check the product and accessories (or attachments)
for wear and damage. If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements.
Lime scale removal
From time to time – according to the nature of your tap water – calcium deposits
form in the product and accessories. The strength of the deposits (and thus the
frequency of removal) depends upon the degree of hardness of the water and
how often the product is used. Check with your local water company in order to
find the hardness of the water in your area.
NOTE:
Use a mixture of water and citric acid or vinegar for lime
scale removal. These substances are readily biodegradable and
environmentally friendly!
1. Make a mixture of one part of vinegar and two parts water in a suitable
container, e. g. in a bucket.
2. Fill the water tank (4) with the mixture.
3. Connect the product to the power supply and let it heat up for 15 minutes.
4. Disconnect the product from the power supply and leave the mixture in the
tank for approximately 1 hour.
5. Then empty the tank and rinse with clear water to remove residue.
NOTE:
Rinse the water tank (4) with 1 litre of water after each use to
reduce lime scale formation.
MNL_TTB926STM_2200W Wallpaper Stripper_GB_V8_220623.indd 20
MNL_TTB926STM_2200W Wallpaper Stripper_GB_V8_220623.indd 20
2022/6/23 下午5:04
2022/6/23 下午5:04
