Titan Lifts PREMIER HD2P-9KFP, Инструкция по установке, эксплуатации и обслуживанию

Страница: 14 / 40

10
Use 5/8” wrench to
tighten the nut.
WARNING: The wiring must comply with local code. Have a certified licensed
electrician make the electrical hook-up to the power unit. Protect each circuit with time delay
fuse or circuit breaker 208v.230v single Phase. 60Hz 30 Amp.
11) Properly route and install the hydraulic hose, then place the hose cover on top. The hose
cover may be anchored to the concrete using the supplied anchors, however, this step is
not required.
12) Install the floor-plate to the base of the columns using the (4) supplied cap head bolts
and washers.
13) Install the power unit to the main side column using the supplied bolts, washers, and
nuts. Install short hose to make the connection between the hydraulic hose fitting on
the cylinder and the hydraulic fitting on the power unit. NOTE: Hydraulic fitting that is
supplied with the power-unit may need to be moved to the port on the opposite side of
the valve body on certain lift models. It is REQUIRED that a licensed electrician make the
electrical hookup to the power unit. NOTE: The electrical test lead that is connected to
the motor is strictly for PRELIMINARY LIFT TESTING AND ADJUSTING ONLY.
14) Install the lifting arms and arm restraint pins. The easiest way to install these is to
remove the cotter pin, washer, and spring, then drop them into the bracket from the top.
Reinstall the spring, washer, and cotter pin after the pin is in place. (Tip: Before installing
the arm restraint pins, remove the ball handles from the pins and spin the treaded plates
down until the top of the gear block is 3 ¼” from the top of the threaded pin.)Adjust the
arm lock gear and the arm lock until they mesh, then tighten the nut of the arm lock.
Bottom
Cable Sheave
Top Cable
Sheave
Equalizing
Cable*2
Carriage
Locking
Nuts*4