12
Removing the cables
First of all unplug the AC adapter from the 230V socket and then remove the
TAE plug from your telephone connections TAE socket.
To remove the cables on the underside of the telephone press (e.g. with a
ballpoint pen) the plugs locking clips towards the body of the plug and pull out
the plug by the cable.
Setting up the handset
Opening the battery compartment and inserting the
batteries
The battery compartment is on the rear of the handset under the Police /
Fire label. The cover of the battery compartment is screwed down for safety
reasons. This means that the compartment cannot accidentally open and that
the batteries are securely fitted.
Unscrew the screw using a Phillips screwdriver and remove the battery
compartment cover (not necessary for initial installation).
Insert the batteries, with the correct polarity (see Fig. 6). You will hear a
confirmation tone.
Fig. 6Fig. 7
Replace the cover (see Fig. 7) and tighten the screw.
Only insert recommended, rechargeable batteries of the
same type! Never use ordinary batteries, as this can lead to
Setting up the telephone
Using several handsets
61
call is active, the other internal party is
connected with the external caller. If the
external call is active, both connections are
broken.
Accepting a waiting call
If you receive an external call during an internal call, you will hear the call
waiting tone (a short tone).
Press the intercom key. The internal call is
ended and you are connected with the
external caller.
Finding the handset (Paging)
Press the Paging key on the base station.
All handsets registered are called.
The call ends when the Lift / Replace key is
pressed on one of the handsets called.
Or
If the Paging key on the base station is
pressed again.
