Tinkerine Studio LITTO, Инструкция по сборке

Страница: 3 / 74

TINKERINE STUDIO STUDIO
support@tinkerines.com | 1-604-288-8778
3
IMPORTANT SAFETY INSTRUCTIONS
!
WARNING
SHARP EDGES
!
WARNING
FIRE
!
WARNING
SHOCK
!
WARNING
HOT SURFACE
Motor surfaces become hot during operation.
There is a danger of electric shock.
Use only undamaged electrical chords.
DO NOT touch bare wires or receptacles.
DO NOT touch the 3D printer or chords if hands
are wet.
Ensure that all cords are free of damage before
connecting to the power supply.
Ensure that you have a sufficient electrical supply for
supporting the requirements of the motor.
Always use your 3D printer in a well-ventilated and
clean area.
Gas emitted by melting of Polylactide (PLA) or
Acrylonitrile butadiene styrene (ABS) can contain
contaminants that are harmful to breathe.
Never breathe the air that comes directly out of the
hotend. This air is not suitable for breathing.
If you feel ill from breathing while operating your 3D
printer, stop and seek medical attention immediately.
Hotend and heater cartridge become hot during
operation.
DO NOT touch hot surfaces, because they can cause
severe burns.
Allow the hotend to cool before touching it without
proper tools.
Use caution to minimize risk of fire. Use caution during assembly and operation of the 3D
printer to ensure no sharp edges will cut you.
Inspect the printer for any damage prior to use.
Always operate the printer a safe distance away from
flammable items. Use in well-ventilated areas.
DO NOT place a storage cover on the unit during
operation. Only place a cover on the printer after it has
thoroughly cooled down.
!
WARNING
Fragile
Electrical pins and sensors are delicate. Handle with
care.
Unless instructed, DO NOT force components together.
Read the instructions carefully to prevent damaing parts
during assembly or operation.
!
WARNING
RISK TO BREATHING