Tinkerine Studio LITTO, Инструкция по сборке

Страница: 47 / 74

TINKERINE STUDIO STUDIO
support@tinkerines.com | 1-604-288-8778
48
3.
4.
1. As shown in Step 3, insert the motor
from the back with the pulley already sitting
in the looped belt from the front. The
tapered end of the pulley should be
pointing away from the motor.
2. Insert the M3 screws to secure the
motor to the frame. Make sure to position
the motor on the frame at a point where the
belt is properly tensioned to avoid giving
the belt any slack.
3. Tighten the setscrew within the pulley on
the flat edge of the motor shaft to secure
the pulley.
4. As shown in Step 4, take a minute to
ensure that all belt are properly aligned.
Belt should always sit perpendicular to the
pulley and should not be angled in any
way. Also make sure the the belt teeth is
fully seated into the grooves of the pulley
and not chewing into the walls of the
pulley. You may need to loosen the sets
screws on the pulley to re-adjust the
positions.
5. Connect the 4-pin motor wire to the port
located on the bottom edge of the motor.
M3x10 (x4)
M3 Washer (x4)