Tineco CARPET ONE Series, Инструкция по эксплуатации

Страница: 29 / 104

EN
27
2.Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Fig.D-2
3.When LED loop illuminates red, remove Dirty
Water Tank, clean the dirt sensor with a damp
cloth or the cleaning tool.
Fig.D-3
Dirty Water Tank
1.When dirty water reaches the Max line,
the appliance will stop working and show
a reminder on the display and play a voice
prompt.
2.Step on the recline pedal and press the DWT
handle to remove it.
3.Pull up the tank lid and mesh filter to empty
the DWT. Use the cleaning tool to remove
remaining debris. Rinse the inside of the DWT
& tank lid & floater & mesh filter and place back
into the appliance.
Note:
Check if the floater is in good condition and
press it to the bottom.
Fig.D-4
Sponge Filter
1.Remove the DWT, take the filter out and wash
it after each use.
Fig.D-5
2.Reinstall.
Fig.D-6
Brush Roller Cover
1.Press brush roller cover release button on the
cover and pull upward to remove.
Fig.D-7
2.Rinse with water. Use the provided cover
scraper to clean the gap in the front side to
avoid blockages.
Fig.D-8
3.When replacing, always latch the brush cover
into place to avoid leakage.
Fig.D-9
Brush Roller
1.Remove the brush roller by squeeze the brush
roller tab and pulling out.
Fig.D-10
2.Using the cleaning tool, remove the hair and
debris wrapped around the roller and rinse
with water. Allow it to dry completely before
reinstalling.
Fig.D-11
3.Remove hair and debris from the brush roller
chamber and the opening with a tissue or a
damp cloth.
Fig.D-12
4.Replace the brush roller by inserting the brush
roller end into the right side of the holder, then
attach the roller tab to the left side to lock into
place.
Fig.D-13
Accessory Hose & 2 in 1 Nozzle
1.Press the buttons on both sides to remove the
hose.
Fig.D-14
2.Press the release button to remove the
accessory brush.
Fig.D-15
3.Remove the top cover and brush head.
Fig.D-16
4.Rinse with water. Allow it to dry completely
before reinstalling.
Fig.D-17
5.Reinstall.
Fig.D-18
Humidity Sensor
• Clean the humidity sensor after each use,
rotate the sensor several times or use the
cleaning tool. Also clean the bristle after each
use.
Fig.D-19