Automatic regulation of burning REG110
5
Produced power of the fire chamber is changed by the combustion mode.
The combustion mode may enter these modes:
•
FM1
economy mode
(in comparison with the optimal mode, the EAI damper is more
closed)
o
This mode is selected if combustion with smaller power is required, e.g. if the heated
area is already warmed.
•
FM2
optimal mode
(the EAI damper is controlled by the selected program corresponding
with the relevant fire chamber)
o
This mode is selected, if there is no requirement for higher power of the fire chamber
needed to burn wood and simultaneously there is no need for the economy mode.
•
FM3
increased mode
(in comparison with the optimal mode, the EAI damper is more
opened)
o
This mode is selected if there is need with for higher power in the fire chamber. For
instance to burn the wood in cold fire chamber, so called cold start.
o
The FM3 mode is automatically set by the control at every start-up of fire in the cold
fire chamber. At every other stoking, the previous mode is automatically set.
It is possible to change the combustion mode using the arrows
and confirming by the button “R”.
3.3
Screen with manual control
By pressing the button
“M”
for the period of
6
sec. we will enter the manual control screen.
MAN
/manual/ shows on the screen.
It is possible to manually set the exact position of the EAI damper in the manual control mode
–
position settings is performed using the arrows (buttons “P” and “M”). The damper changes by 5%.
By pressing the button
“R”
we return back into the automatic mode.
By switching from the automatic to the manual mode, the user assumes responsibility for
any damages caused by manual intervention.
3.4
Settings screen
By pressing the button
“
P
”
for the period of
5
sec. we will enter the settings screen.
Options:
•
sound signalization
–
bep
parameter
o
settings of the sound signalization
(„on“
or
„off“)
o
the sound signalization notifies the user about the control start, it notifies if it is
necessary to add more wood and informs the user about switching into the idle state
•
screen brightness
–
jas
parameter
o
settings of the screen brightness - from 1 to 5 (5 = the brightest)
•
software door switch (SDS)
–
sds
parameter
o
ON/OFF
SDS („on“
or
„off“)
o
see Chapter 3.1
•
screen fading
–
sut
parameter
o
on/off of the screen fading if inactive for more than 1 min
The parameter is selected using the arrows and with subsequent confirmation by pressing the button
“R”.
Then, using the arrows the required value is selected by confirmed by the button
“R”.
