Automatic regulation of burning REG110
4
3
SCREENS DESCRIPTION
3.1
Main screen
Indication of the active software door switch
Shows the activity of SDS
–
the SDS checks the temperature changes of combustion products.
The SDS is an in-built software, which, based on the temperature changes (decrease or increase) of
the combustion products in fire chamber, recognizes the add wood or opening of the fire chamber
door. For correct start of regulation of burning with SDS, the door must be open for at least 20
seconds, when you are putting wood into the fireplace. Based on the temperature change, the SDS
automatically performs a new start of the combustion control process (see Chapter 5.1).
•
SDS works both during start the fire and add wood
o
SDS is active during displaying the information on the main screen.
•
It is possible to turn on/off the SDS in the settings (see Chapter 3.4)
SDS is not an adequate replacement for the mechanical door switch
–
it is not
recommended to activate it at the installations, where the temperature sensor of the
combustion products is affected by hot-water or accumulative exchanger.
Current value displayed on the screen
There are two figures you may view.
S-1
position of the EAI damper
–
you can view this information in percentage from 0 to
100 (100% = the EAI damper is fully opened and the largest volume of air goes into
the fire chamber, 0% = the damper is fully closed the no air goes into the fire
chamber)
•
T-1
current temperature of the combustion products in the
fire chamber (in °C)
3.2
The screen with combustion modes
By pressing the button
“M”
for the period of
3
sec. we will enter the settings screen.
F-M
/fire mode/ shows on the screen
Current combustion mode is displayed.
Current value displayed on the
screen
Indication of the active
software door switch
Indication of the automatic
control mode
Indication of the
manual control mode
Indication of the time delay
