Timken StatusCheck, Быстрый старт

Страница: 22 / 24

20
Inability to catch problems:
• Be sure that the thresholds are set appropriately for each given
operating condition.
• Be sure that the proper selection of the accelerometer internal to the
end node is being used for each operating condition.
• Be sure the end node is mounted properly and in a location as close to
the source of vibration (or heat) as possible.
• Determine if the machine that is being monitored fails in a way that can
be monitored by these devices.
Too many false alarms:
• Be sure thresholds are set properly.
• Check that the transient conditions of the application are accounted for.
This might mean trending more data points or adjusting the number of
consecutive data points that must surpass the threshold prior to
alarming.
Controller not receiving:
• Be sure the router/controller switch, located inside the box, is set to
“controller.”
• Be sure line power is connected to the controller. Move power switch,
located on bottom of controller, to the on (right) position. A green LED
should illuminate with power on.
• Check for proper data interface connections. If using USB cable as a
data interface, be sure drivers are installed.
• Be sure the proper com port is selected in the StatusCheck software.
See step 6 in the quick start guide.