Timewave DSP-599zx, Руководство по эксплуатации

Страница: 87 / 106

DSP-599zx Audio Noise Reduction Filter
March 6, 1997 7-11
10. Press the left knob to select.
11. Rotate left knob until the reading on the meter reads 512 millivolts.
12. Press the left knob to select. Press middle knob to escape without sav-
ing changes.
13. Reconnect the meter to channel B line out and repeat steps 2 - 9 except
for channel
B
.
14. Rotate left knob until your next function to change appears on the bot-
tom line of the display or press the middle knob to return to main set-
up menu.
Millivoltmeter Calibration
Again, like the previous calibration, it will usually not be required. If you do
this procedure, proceed with caution. You will need to have the inputs set
for high impedance. See page 2-4 for this procedure.
1. Connect jumper cable from Line Output on channel A to audio Input
on channel
A
.
2. Press
[Shift+Mode]
twice to enter Setup mode.
3. Rotate left knob until 7HVW appears on the bottom line of the display
4. Press the left knob to select.
5. Rotate left knob until $GM ,QS $ appears on the bottom line of the
display
6. Press the left knob to select.
7. Rotate left knob until the P9 appears on the bottom right of the
display
8. Press the left knob to accept choice and save. Press middle knob to
escape without saving changes.
9. Reconnect the jumper cable from Line Output on channel B to audio
Input on channel
B
.
10. Repeats sets 2 - 5 for channel
B
.
11. Rotate left knob until your next function to change appears on the bot-
Function
6
Shift
5
AGC
3
Bypass
Setup Test Data
DSP-599zx
CW Voice
Mode
Rcl/ Store
Spkr/ Chan
1
Random
4
Tone
2
599-087
High Pass
Center Freq
Time