Timewave DSP-599zx, Руководство по эксплуатации

Страница: 60 / 106

5 – CW Mode
5-4 March 6, 1997
Let’s use for example a Kenwood transceiver with an 800 Hz CW
pitch and we would like to change it to 365 Hz.
1. Press [Shift+Function].
2. Rotate the middle knob
[Bandwidth]
to display ,&) (the
input CW pitch from the radio).
3. Rotate the left knob
[Center Frequency]
to display &)n
(the output CW pitch you want to hear).
4. Press
[Shift+Function]
or the left knob to switch back to standard
operating mode.
The colon after
&)
has been replaced with a arrow indicating that you have
programmed in a pitch shift and it is up or down. The CW pitch shift will
remain the same until it is reprogrammed to a new frequency with the above
procedure or deactivated.
• To remove the pitch shift, press [Shift+Function]. Then press middle
knob to deactivate.
CW Bypass Mode
Press [Bypass] to place the DSP-599zx into a bypass mode. In this mode,
a relay connects the audio input jacks of the DSP-599zx directly to the
speaker, line, and headphone output jacks. The Bypass mode has prece-
dence over the CW mode. When the DSP-599zx is in bypass, the settings of
the all other controls do not affect the signal.
Bypass respects the status of the speaker switch. If the speaker is turned off,
bypass leaves it off. The speaker will always, however, come on when pow-
er is turned off on the DSP-599zx. Turning off or removing power from the
DSP-599zx automatically de-energizes the relay and forces the DSP-599zx
into the bypass mode.
Function
6
Shift
5
AGC
3
Bypass
Data
DSP-599zx
CW Voice
Mode
1
Random
4
Tone
2
599-008
Setup Test
Rcl/ Store
Spkr/ Chan
High Pass
Center Freq
Time