Timeless Wings CASA C-101 AVIOJET, Руководство по монтажу

Страница: 24 / 30

24

Build the LHS wing in the same way as the RHS. Add scrap balsa gussets for
the middle centre-section rib, as well as for the aileron hinges. Install the
aileron servo extension leads.

Cutouts and structure for the aileron servo mountings are best added now. This
varies according to builder preference – see the plans and photo below to see how
the prototype was done.

Sheet the top of the wings and centre-section with 1.5mm balsa, making provision
for the aileron extension leads to be routed through the centre-section sheet.

Laminate the WING TIPS (WT1) then glue in position, along with CS4 (NOTE: CS4 in
the kit is erroneously made from 3mm balsa, instead of 6.5mm balsa, so please
laminate with scrap 3mm balsa to give correct thickness) and CS5 (lower surface of
the wing). The AILERONS are now temporarily hinged, and the whole wing is shaped
and smoothed.
 Fit the 3mm dowels in the leading edge of the wing and carefully measure the rear of
wing to make hole for wing bolt to pass through, then glue CS5 to lower surface of
wing.