8
• The unit will now operate during daytime as well as at night, illuminating the
lamp for approx. 2 seconds each time. This allows testing to be carried out to
establish whether the sensor is covering the required area.
• Walk across the location the sensor is fitted, to establish the detection zone.
• The sensor will detect you approximately up to 10 meters forward at mounting
height of 2.5m.
• As you cross the detection “zone” the lamp will illuminate. Now stand still
until the lamp extinguishes (this should take approx. 2 seconds).
• Start moving again after 5 seconds. Each time you cross the detection “zone”
the lamp will illuminate.
• Repeat the above, walking at various distances and angles to the unit.
This will help you to confirm the detection pattern.
Setting Up for Automatic Operation (Auto Mode)
• When walk tests are complete, the unit can be adjusted for automatic operation.
• The TIME ON adjustment controls how long the unit remains illuminated
following activation and after all motion ceases.
• Use a thin flat blade screwdriver to make adjustments. We recommend using
the knob adjuster included in the accessory pack to adjust the Time and Lux
settings, however a thin flat head screwdriver or a 2.5mm Allen key
could also be used.
• This can be set between 2 seconds to a maximum of 30 minutes.
• Set the control to the desired setting between these limits.
• The LUX Level adjustment determines the level of darkness required for the unit
to start operating. The setting is best achieved by the procedure below;
1. Set the LUX Level adjustment knob fully clockwise (Sun symbol).
2. When the ambient light level reaches the level of darkness at which you
wish the lamp to become operative (i.e. at dusk) SLOWLY rotate the
control in an anti-clockwise direction until a point is reached where
the lamp illuminates.
3. Leave the control set at this point.
• At this position the unit should become operative at approximately
the same level of darkness each evening.
• Observe the operation of the unit. If the unit is starting to operate
too early (i.e. when it is quite light) adjust the control slightly anti-clockwise.
