Getting Started Guide
5
• RS-232 Cable (optional)
A DB9 male-to-female RS-232 cable is needed if the user intends to
communicate with the PulsON 200 using a terminal application ( e.g. `HyperTerminal’)
running on a PC. Examples of RS 232 use include Built-In Test (BIT) results and radio
internet protocol (IP) address modification. Both topics are covered later in this document.
Configuring the Hardware
Please be careful when you remove the units and the antenna assemblies from their boxes. The
antenna solder joint between the antenna plane and the end-launch connection can be damaged if
handled improperly. Please inspect this connection and contact TDC if there appears to be a problem.
Also inspect the PulsON 200 radios for damage, including loose or missing screws. Contact TDC if
there is a problem.
1.
Using a Phillips-head screwdriver, attach the Broadspec
™
Model P200 antennas to the
antenna brackets on the rear of the units.
2.
Connect the antenna cable to the port labeled
ANTENNA
. The antenna is omni-
directional. Once connected, do not adjust the antenna orientation as it may overstress the
attached cable through unnecessary bending.
Use of another antenna element other than the one provided in the kit is a violation of FCC rules
governing the transmission of UWB signals
Ensure that the cable connector nut is firmly tightened over the connection to avoid accidental
disconnection. Do NOT over-tighten. Seven to ten inch-pounds torque using an approved connector
wrench (Huber & Suhner, part number 74Z0-0-21 or equivalent) is recommended. The connector
center pins on the cables are fragile. If you meet resistance when connecting a cable to a port, either
during insertion or when tightening the connector nut, do not force the connection. Abort this attempt
and try again. Damage to the connecter caused by over-tightening is not covered by the warranty
.
3. Connect the supplied power supply to the
POWER IN
interface (Fig. 1).
Initial System Power-Up
The radio is now ready to be powered on. To turn the radio on, place the power switch on the rear
panel in the
ON
position. The rear panel LEDs will activate in the following sequence:
1. As soon as the power switch is placed in the “on” position, the LED on the right side labeled
POWER
will turn on and remain lit with a steady glow.
2. Almost immediately after the
POWER
LED turns on, the LED labeled
HEARTBEAT
will turn
on and remain lit with a steady glow.
Proprietary Information: Do not disclose unless authorized under the the PulsON Developers Program Nondisclosure Agreement
